Mounting faces
State the flatness, perpendicularity or other relationships that your design requires between mounting surfaces.
Bore & mounting base
A locating bore above a base with counterbored mounting holes.
CNC milling
Brackets & blocks
Made to your drawings.
Mounting faces, bores and slots support components, locate them within an assembly and allow adjustment where specified.
Aluminum alloys, stainless steel and steel to the grade on your drawing. Material selection remains part of your design specification and the quotation review.
Mounting faces. Bores, holes & slots. Finished surfaces.
Specify anodizing, plating or other required treatment, including colour or appearance references where relevant. Functional surfaces and post-treatment dimensions are reviewed explicitly.
Custom brackets and blocks can position sensors, support components and connect parts of an equipment assembly. Your design defines the load-bearing geometry and the interfaces that need to align.
What defines this part
Mounting faces, bores and slots.
Slotted brackets, split mounting blocks and U-shaped supports.
Bores, holes & slots
Locating bores, adjustment slots and fastener holes are reviewed against the assembly datums.
Finished surfaces
Identify cosmetic surfaces, thread protection and any area where treatment affects a functional fit.
Your part. Fully specified.
Material & condition
Aluminum alloys, stainless steel and steel to the grade on your drawing. Material selection remains part of your design specification and the quotation review. Material grades and conditions
Finish & treatment
Specify anodizing, plating or other required treatment, including colour or appearance references where relevant. Functional surfaces and post-treatment dimensions are reviewed explicitly. Finishing requirements
Inspection
Inspection can cover specified bore sizes, hole locations and mounting-face relationships. Agree the report scope and any appearance acceptance reference during quotation. Inspection before shipment
Repeat orders
A repeat bracket must match the approved revision and finish requirement. We review design and treatment changes with you before proceeding with a new batch. Repeat-order supply
